HCIATTACH(8)              Linux System Administration             HCIATTACH(8)


       hciattach - attach serial devices via UART HCI to BlueZ stack


       hciattach  [ -n ] [ -p ] [ -t timeout ] < tty > < type | id > [ speed ]
       [ flow ]


       Hciattach is used to attach a serial UART to the Bluetooth stack as HCI
       transport interface.


       -n     Don’t detach from controlling terminal.

       -p     Print the PID when detaching.

              Specify an initialization timeout.  (Default is 5 seconds.)

       <tty>  This  specifies  the serial device to attach. A leading /dev can
              be omitted. Examples: /dev/ttyS1 ttyS2

       <type | id>
              The type or id of the Bluetooth device that is to  be  attached,
              i.e.  vendor or other device specific identifier. Currently sup-
              ported types are

              type   description

              any    Unspecified  HCI_UART  interface,  no   vendor   specific

                     Ericsson based modules

              digi   Digianswer based cards

              xircom Xircom  PCMCIA  cards:  Credit Card Adapter and Real Port

              csr    CSR Casira serial adapter  or  BrainBoxes  serial  dongle

              bboxes BrainBoxes PCMCIA card (BL620)

              swave  Silicon Wave kits

              bcsp   Serial adapters using CSR chips with BCSP serial protocol

       Supported IDs are (manufacturer id, product id)

              0x0105, 0x080a
                     Xircom PCMCIA cards: Credit Card Adapter  and  Real  Port

              0x0160, 0x0002
                     BrainBoxes PCMCIA card (BL620)

              The speed specifies the UART speed to use. Baudrates higher than
              115.200bps require vendor specific initializations that are  not
              implemented  for  all types of devices. In general the following
              speeds are supported:

              9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600

              Supported vendor devices are automatically initialised to  their
              respective best settings.

       <flow> If  the  keyword  flow  is  appended to the list of options then
              hardware flow control is forced on the serial link ( CRTSCTS  ).
              All  above  mentioned  device types have flow set by default. To
              force no flow control use noflow instead.


       Written by Maxim Krasnyansky <maxk@qualcomm.com>

       Manual page by Nils Faerber <nils@kernelconcepts.de>

BlueZ                             Jan 22 2002                     HCIATTACH(8)

Man(1) output converted with man2html