g3cat(1) mgetty+sendfax manual g3cat(1)
g3cat - concatenate multiple g3 documents
g3cat [-l] [-a] g3-file1 ...
g3cat concatenates g3 files. These can either be ’raw’, that is,
bitmaps packed according to the CCITT T.4 standard for one-dimensional
bitmap encoding, or ’digifax’ files, created by GNU’s GhostScript pack-
age with the digifax drivers. Its output is a concatenation of all the
input files, in raw G3 format, with two white lines in between.
If a - is given as input file, stdin is used.
If the input data is malformed, a warning is printed to stderr, and the
output file will have a blank line at this place.
-l separate files with a one-pixel wide black line.
-h <blank lines>
specifies the number of blank lines g3cat should prepend to each
page. Default is 0.
limit lenght of output page to maximum <lines> lines.
specifies the desired page width in pixels per line. Default is
1728 PELs, and this is mandatory if you want to send the fax to
a standard fax machine. If one of the input files doesn’t match
this line width (for example because it was created by a broken
G3 creator), a warning is printed, and the line width is trans-
-a byte-align the end-of-line codes (EOL) in the file. Every EOL
will end at a byte boundary, that is, with a 01 byte.
specifies a minimum number of bytes that each output line must
be padded to. Padding is done with 0-bits before the EOL code.
-R suppress output of end-of-page code (RTC).
The following example will put a header line on a given g3 page,
’page1’ and put the result into ’page2’:
echo ’$header’ | pbmtext | pbm2g3 | g3cat - page1 >page2
Hopefully none :-).
g32pbm(1), sendfax(8), faxspool(1)
g3cat is Copyright (C) 1993 by Gert Doering, <firstname.lastname@example.org>
greenie 27 Oct 93 g3cat(1)
Man(1) output converted with